Pearson logo Pearson logo

Spars

  • Mast
    • Sound Spars 7747
    • Oval cross-section, 7 3/4" x 4 3/4"
    • OEM Length: ??
    • Shortened by 2 1/4" on Oct 2012 to Remove Corrosion, Current Spar Length xxx' xxx"
    • OEM Color: Black Awlgrip
    • Striped and repainted with Black Awlgrip May 2013
    • Internal, welded wire conduit, not used by OEM, rewired for use Jun 2013
  • Mast Collar
    • Special Pearson Cast Aluminum Deck Collar
    • Incorporates Deck Anchor Point for Tension Rod
    • Not Available From RigRite
  • Mast Boot
    • OEM - Rig-Rite Part Number SS-7747MB
    • As Purchased - Sealed With Self-fusing Wide Rigging Tape
    • Replaced with Universal Mast Boot and Clamps, Jun 2013
  • Spreaders - RigRite Part Number SP-512, tapered, with "twist-lock" tip
    • Repair-welded split ends at base, Nov 2012
  • Spreader Bases - Rig-Rite part numbers SS 7747SB-P (Port), SS 7747SB-S (Starboard)
  • Upper Shroud Tangs - 1/2" hole for Clevis Pin, Fastened with four ?? x ?? screws, with locknuts inside of mast.
  • Lower Shroud Tangs - 1/2" holes for fore and aft shroud's clevis pins, Fastened with 6 1/2" x 3/4" x 10 TPI SS through bolt, Aluminum Compression Tube 1" OD x .75" ID
  • Masthead Fitting
    • OEM Color: Black Awlgrip
    • Hole drilled in Spinnaker Beak Web to Allow Use of Drift Pin to Drive out Stuck Sheave Pin, Oct 2013
    • Striped and repainted with Black Awlgrip May 2013
    • External Halyards, Main & Jib
    • OEM: 4 Identical Solid Aluminum Sheaves
    • Replaced All 4 Sheaves May 2013
      • New Sheaves fabricated by ZephyrWerks
      • Black Delrin
      • Bronze Bushing
      • Grooved for All-Rope, 3/8" Dia
      • Groove Depth 5/32"
      • Sheave Diameter: 2.505"
      • Sheave Width: 0.493"
      • Bushing Inner Dia: 0.375"
  • Instrumentation & Lights
  • Mast Step
  • Boom
    • Model SS-7747 ???? (appears same as mast)
    • Oval Cross Section
    • OEM Length: ??
    • OEM Color: Black Awlgrip
    • Striped and repainted with Black Awlgrip May 2013
    • Schafer Goosneck with Reefing Hooks Port & Starboard

Standing Rigging

  • Forestay
    • 9/32" 1x19 SS Wire
    • Swaged Toggle at top, with extra extensions
    • Harken Unit 1?? Roller Furling, 1/2" pin
  • Backstay
    • 9/32" 1x19 SS Wire
    • Swaged Toggle at top, 1/2" pin
    • Navtec C500 turnbuckle with Integral Toggle at bottom, 1/2" hole & pin
    • Chainplate - 1/2" hole
  • Upper Shrouds
    • 9/32" 1x19 SS Wire
    • Swaged Eye at top, 7/16" hole & pin (note mismatch with tang!)
    • Navtec C500 turnbuckle with Integral Toggle at bottom, 1/2" hole & pin
    • Chainplates - 1/2" hole
  • Fwd Lower Shrouds
    • 1/4" 1x19 SS Wire
    • Swaged Eye at top, 1/2" hole & pin
    • Lower Tang - 1/2" hole
    • Navtec C500 turnbuckle with Integral Toggle at bottom, 1/2" hole & pin
    • Chainplates - 1/2" hole
  • Aft Lower Shrouds
    • 1/4" 1x19 SS Wire
    • Swaged Eye at top, 1/2" hole & pin
    • Lower Tang - 1/2" hole
    • Navtec C500 turnbuckle with Integral Toggle at bottom, 1/2" hole & pin
    • Chainplates - 1/2" hole
  • Spreaders

Running Rigging

  • Main Halyard
    • OEM Wire/Rope: 3/16" wire, 7/16" rope
    • Replaced May 2013: 100' of 3/8" New England Ropes' VPC with Green Fleck
  • Topping Lift
    • ?/?" wire, with small block adjuster at boom end
  • Jib Halyard
    • OEM Wire/Rope: 3/16" wire, 7/16" rope
    • Replaced May 2013: 110' of 3/8" New England Ropes' VPC with Red Fleck
  • Spinnaker Halyard
    • 1/2" x ??', Old, needs replacement
  • Main Sheet
    • ??
  • Jib Sheets
    • ??

Sails

  • Main
  • Jib
  • Storm Jib
  • Spinnaker